AC Motor in a plastic body  

Dimensions

Length 280 mm, Diameter 67 mm

Cutting

High-speed oscillating head with 10,000 oscillation angle of 5°

Weight:

1100 g

Temperature

operating temperature +10 - +60 deg C (+50 - +140 deg F)

Motor:

AC 220-240 V, Input Power 70W, 50/60Hz

SterilizatioN

Not sterilizeable

How to Use
Insert the blade onto the blade attachment plate and tighten the blade cap bolt. Ensure that the cover sits firm onto the blade and that these two parts sit tight onto the blade attachment flange. Do not over-tighten the blade fastening bolt.

Hold the cast cutter handpiece firmly by one hand and let the other hand hold the cast or the patient. Support the cast cutter by placing your thumb in front of the cast cutter. This will enable you to control the depth of the cast cutter blade. 

Start cutting by horizontally penetrating the cast. As soon as the cast is penetrated, tilt the handpiece 45° backward, as shown in Picture. Note: You will notice that the PrimeCutter™ cast cutter tends to move forward, along the planned cutting line, by itself. You do NOT need to apply pressure to the handpiece, just guide the handpiece along the planned cutting line. Applying excessive pressure to the cast cutter during cutting will increase the cutter blade temperature, which might cause pain or burns to the patient’s skin.

During cutting make small rotations of the cast cutter handpiece (Picture). This prevents the cast cutter blade from getting stuck in the cast and improves cutting by constantly removing the cast grains produced by cutting.



 

As soon as the teeth of the cutter blade become rounded, a major reduction of cutting effect will be observed. Unscrew the blade cap and rotate the cutter blade position and use new area of the blade.